A turbocharger spins very fast and runs very hot, so it relies on clean oil, clean air and a free-flowing exhaust. Most turbo failures start with a problem in one of those systems rather than a fault in the turbo itself. If the cause isn't fixed, the replacement turbo is likely to fail the same way.
Oil starvation
The turbo's bearings run on a film of engine oil. If oil supply is late, low or interrupted, bearings wear quickly.
- Common causes: low oil level, a blocked or kinked oil feed line, sludge, a wrong or worn-out oil filter, or not priming a new turbo before first start.
- Signs: blue-tinted or scored shaft, worn bearings, the wheels rubbing the housings.
Oil contamination
Dirt, carbon or metal in the oil scores the bearings and shaft.
- Common causes: overdue oil changes, the wrong oil, or debris from another engine failure.
- Signs: scratched bearing surfaces and shaft journals.
Foreign objects
Anything that gets into the compressor or turbine damages the blades.
- Compressor side: a damaged air filter, a loose intake hose, or debris left in the intake during a repair.
- Turbine side: pieces of a failed valve, injector tip or broken manifold.
- Signs: chipped, bent or rounded blade tips.
Restricted intake or exhaust
A blocked air filter, collapsed intake hose, blocked DPF or damaged exhaust changes the pressure balance across the turbo. This can push oil past the seals and overload the bearings.
Oil leaks that aren't the turbo's fault
Oil in the intercooler or smoke from the exhaust is often blamed on turbo seals. Blocked oil drain lines and high crankcase pressure (blow-by) are common causes. Check them before you condemn the turbo.
Heat and shut-down habits
Your turbo spins very fast and gets very hot, and it relies on engine oil to cool and lubricate it. If you switch off straight after working the engine hard, the oil stops flowing while the turbo is still hot, and that oil can burn and leave hard deposits that wear out the bearings.
Our recommendation:
- Normal driving around town: just switch off as usual. The last few minutes of easy driving have already cooled it down.
- After towing, a long climb, highway driving at high speed or hard work: let it idle for 1 to 2 minutes before switching off.
- After heavy towing in the heat or hard off-road work: idle for 3 to 5 minutes.
- An easy way to do it: drive the last few kilometres gently, then idle while you get sorted before turning the key.
Actuator and control faults
Variable-geometry turbos rely on an actuator, and many diesels use a boost or vacuum control solenoid. A faulty actuator, solenoid or vacuum line can cause low boost, over-boost or limp mode, and the turbo itself may be fine.
Before fitting a replacement
- Find and fix the cause of the failure.
- Change the engine oil and filter, and replace the oil feed line if needed.
- Check the oil drain line is clear, and check crankcase pressure.
- Clean out the intercooler and pipes if the old turbo lost parts.
- Prime the new turbo with clean oil before first start.
For help choosing a replacement, see Reman vs new turbo.
